All issues

We study the motion and destruction of Chelyabinsk meteoroid using simple physical and mathematical models. We evaluate the parameters of the motion, taking into account the ablation and mechanical destruction of the meteoroid, and compare our results to the observation data.

The paper provides a review of the existing methods of signals’ processing within the conditions of the Rice statistical model applicability. There are considered the principle development directions, the existing limitations and the improvement possibilities concerning the methods of solving the tasks of noise suppression and analyzed signals’ filtration by the example of magnetic-resonance visualization. A conception of a new approach to joint calculation of Rician signal’s both parameters has been developed based on the method of moments in two variants of its implementation. The computer simulation and the comparative analysis of the obtained numerical results have been conducted.

Mathematical simulation of natural convection and surface radiation in a square air enclosure having isothermal vertical walls with a local heat source of constant temperature has been carried out. Mathematical model has been formulated on the basis of the dimensionless variables such as stream function, vorticity and temperature by using the Boussinesq approximation and diathermancy of air. Distributions of streamlines and isotherms reflecting an effect of Rayleigh number $ 10^3 \leqslant Ra \leqslant 10^6 $, surface emissivity $0 \leqslant ε < 1$, ratio between the length of heat source and the size of enclosure $0.2 \leqslant l/L \leqslant 0.6$ and dimensionless time $0 \leqslant τ \leqslant 100$ on fluid flow and heat transfer have been obtained. Correlations for the average heat transfer coefficient in dependence on $Ra$, $ε$ and $l/L$ have been ascertained.

It is discussed peculiarities of forming gas temperature fields in gas turbine engine low emission combustors. It is shown the influence of burn-up rate on combustor outlet temperature and proposed recommendation for design the dilution system for the combustor.

A model of forest insect population dynamics used to simulate of “forest-insect” interactions and for estimation of possible damages of forest stand by pests. This model represented a population as control system where the input variables characterized the influence of modifier (climatic) factors and the feedback loop describes the effect of regulatory factors (parasites, predators and population interactions). The technique of stress testing on the basis of population dynamics model proposed for assessment of the risks of forest stand damage and destruction after insect impact. The dangerous forest pest pine looper Bupalus piniarius L. considered as the object of analysis. Computer experiments were conducted to assess of outbreak risks with possible climate change in the territory of Central Siberia. Model experiments have shown that risk of insect impact on the forest is not increased significantly in condition of sufficiently moderate warming (not more than 4 °C in summer period). However, a stronger warming in the territory of Central Siberia, combined with a dry summer condition could cause a significant increase in the risk of pine looper outbreaks.

The technique of simplification of mathematical model of a chemical reaction by reducing the number of steps of the reaction scheme, based on an analysis of sensitivity to changes in the objective function of the model parameters, is proposed. The reduced scheme of model reaction of formaldehyde oxidation is received. Functional characterizes the measure of proximity to the calculated values for the initial kinetic reaction scheme and the scheme resulting disturbance of its parameters. The advantage of this technique is the ability to analyze complex kinetic schemes and reduction of kinetic models to a size suitable for practical use. The results of computational experiments under different reaction conditions can be included in the functional and thus to receive the reduce scheme, which is consistent the detailed scheme for the desired range of conditions. Sensitivity analysis of the functional model allows to identify those parameters, which provide the largest (or smallest) the contribution to the result of the process simulation. The mathematical model can contain parameters, which change of values do not affect the qualitative and quantitative description of the process. The contribution of these parameters in the functional value won’t be of great importance. Thus it can be eliminated from consideration, which do not serve for modeling kinetic curves substances. The kinetic scheme of formaldehyde oxidation, the detailed mechanism which includes 25 stages and 15 substances, were investigated using this method. On the basis of the local and global sensitivity analysis, the most important stage of the process that affect the overall dynamics of the target concentrations of the reaction. The reduced scheme of model reaction of formaldehyde oxidation is received. This scheme also describes the behavior of the main substances, as detailed scheme, but has a much smaller number of reaction stages. The results of the comparative analysis of modeling of formaldehyde oxidation on detailed and reduced schemes are given. Computational aspects of the problems of chemical kinetics by Sobol’ global method an example of this reaction are specified. The comparison results are local, global and total sensitivity indices are given.

This article represents numerical simulation technique for determining effective spectral electromagnetic properties (effective electrical conductivity and relative dielectric permittivity) of saturated porous media. Information about these properties is vastly applied during the interpretation of petrophysical exploration data of boreholes and studying of rock core samples. The main feature of the present paper consists in the fact, that it involves three-dimensional saturated digital rock models, which were constructed based on the combined data considering microscopic structure of the porous media and the information about capillary equilibrium of oil-water mixture in pores. Data considering microscopic structure of the model are obtained by means of X-ray microscopic tomography. Information about distributions of saturating fluids is based on hydrodynamic simulations with density functional technique. In order to determine electromagnetic properties of the numerical model time-domain Fourier transform of Maxwell equations is considered. In low frequency approximation the problem can be reduced to solving elliptic equation for the distribution of complex electric potential. Finite difference approximation is based on discretization of the model with homogeneous isotropic orthogonal grid. This discretization implies that each computational cell contains exclusively one medium: water, oil or rock. In order to obtain suitable numerical model the distributions of saturating components is segmented. Such kind of modification enables avoiding usage of heterogeneous grids and disregards influence on the results of simulations of the additional techniques, required in order to determine properties of cells, filled with mixture of media. Corresponding system of differential equations is solved by means of biconjugate gradient stabilized method with multigrid preconditioner. Based on the results of complex electric potential computations average values of electrical conductivity and relative dielectric permittivity is calculated. For the sake of simplicity, this paper considers exclusively simulations with no spectral dependence of conductivities and permittivities of model components. The results of numerical simulations of spectral dependence of effective characteristics of heterogeneously saturated porous media (electrical conductivity and relative dielectric permittivity) in broad range of frequencies and multiple water saturations are represented in figures and table. Efficiency of the presented approach for determining spectral electrical properties of saturated rocks is discussed in conclusion.

The reentry vehicle of the transportation spacecraft that is being created by RSC Energia in regular mode makes soft landing on land surface using a parachute system and thruster devices. But in not standard situations the reentry vehicle also is capable of executing a splashdown. In that case, it becomes important to define the hydrodynamics impact on the reentry vehicle at the moment of the first contact with the surface of water and during submersion into water medium, and to study the dynamics of the vehicle behavior at more recent moments of time.

This article presents results of numerical studies of hydrodynamics forces on the conical vehicle during splashdown, done with the FlowVision software. The paper reviews the cases of the splashdown with inactive solid rocket motors on calm sea and the cases with interactions between rocket jets and the water surface. It presents data on the allocation of pressure on the vehicle in the process of the vehicle immersion into water medium and dynamics of the vehicle behavior after splashdown. The paper also shows flow structures in the area of the reentry vehicle at the different moments of time, and integral forces and moments acting on the vehicle.

For simulation process with moving interphases in the FlowVision software realized the model VOF (volume of fluid). Transfer of the phase boundary is described by the equation of volume fraction of this continuous phase in a computational cell. Transfer contact surface is described by the convection equation, and at the surface tension is taken into account by the Laplace pressure. Key features of the method is the splitting surface cells where data is entered the corresponding phase. Equations for both phases (like the equations of continuity, momentum, energy and others) in the surface cells are accounted jointly.

Efficiency of production directly depends on quality of the management of technology which, in turn, relies on the accuracy and efficiency of the processing of control and measuring information. Development of the mathematical methods of research of the system communications and regularities of functioning and creation of the mathematical models taking into account structural features of object of researches, and also writing of the software products for realization of these methods are an actual task. Practice has shown that the list of parameters that take place in the study of complex object of modern production, ranging from a few dozen to several hundred names, and the degree of influence of each factor in the initial time is not clear. Before working for the direct determination of the model in these circumstances, it is impossible — the amount of the required information may be too great, and most of the work on the collection of this information will be done in vain due to the fact that the degree of influence on the optimization of most factors of the original list would be negligible. Therefore, a necessary step in determining a model of a complex object is to work to reduce the dimension of the factor space. Most industrial plants are hierarchical group processes and mass volume production, characterized by hundreds of factors. (For an example of realization of the mathematical methods and the approbation of the constructed models data of the Moldavian steel works were taken in a basis.) To investigate the systemic linkages and patterns of functioning of such complex objects are usually chosen several informative parameters, and carried out their sampling. In this article the sequence of coercion of the initial indices of the technological process of the smelting of steel to the look suitable for creation of a mathematical model for the purpose of prediction is described. The implementations of new types became also creation of a basis for development of the system of automated management of quality of the production. In the course of weak correlation the following stages are selected: collection and the analysis of the basic data, creation of the table the correlated of the parameters, abbreviation of factor space by means of the correlative pleiads and a method of weight factors. The received results allow to optimize process of creation of the model of multiple-factor process.

Nowadays the random search became a widespread and effective tool for solving different complex optimization and adaptation problems. In this work, the problem of an average duration of a random search for one object by another is regarded, depending on various factors on a square field. The problem solution was carried out by holding total experiment with 4 factors and orthogonal plan with 54 lines. Within each line, the initial conditions and the cellular automaton transition rules were simulated and the duration of the search for one object by another was measured. As a result, the regression model of average duration of a random search for an object depending on the four factors considered, specifying the initial positions of two objects, the conditions of their movement and detection is constructed. The most significant factors among the factors considered in the work that determine the average search time are determined. An interpretation is carried out in the problem of random search for an object from the constructed model. The important result of the work is that the qualitative and quantitative influence of initial positions of objects, the size of the lattice and the transition rules on the average duration of search is revealed by means of model obtained. It is shown that the initial neighborhood of objects on the lattice does not guarantee a quick search, if each of them moves. In addition, it is quantitatively estimated how many times the average time of searching for an object can increase or decrease with increasing the speed of the searching object by 1 unit, and also with increasing the field size by 1 unit, with different initial positions of the two objects. The exponential nature of the growth in the number of steps for searching for an object with an increase in the lattice size for other fixed factors is revealed. The conditions for the greatest increase in the average search duration are found: the maximum distance of objects in combination with the immobility of one of them when the field size is changed by 1 unit. (that is, for example, with $4 \times 4$ at $5 \times 5$) can increase the average search duration in $e^{1.69} \approx 5.42$. The task presented in the work may be relevant from the point of view of application both in the landmark for ensuring the security of the state, and, for example, in the theory of mass service.