All issues

This paper presents a methodology for modeling centrifugal pumps using the example of the NM 1250 260 main oil centrifugal pump. We use FlowVision CFD software as the numerical modeling instrument. Bench tests and numerical modeling use water as a working fluid. The geometrical model of the pump is fully three-dimensional and includes the pump housing to account for leakages. In order to reduce the required computational resources, the methodology specifies leakages using flow rate rather than directly modeling them. Surface roughness influences flow through the wall function model. The wall function model uses an equivalent sand roughness, and a formula for converting real roughness into equivalent sand roughness is applied in this work. FlowVision uses the sliding mesh method for simulation of the rotation of the impeller. This approach takes into account the nonstationary interaction between the rotor and diffuser of the pump, allowing for accurate resolution of recirculation vortices that occur at low flow rates.

The developed methodology has achieved high consistency between numerical simulations results and experiments at all pump operating conditions. The deviation in efficiency at nominal conditions is 0.42%, and in head is 1.9%. The deviation of calculated characteristics from experimental ones increases as the flow rate increases and reaches a maximum at the far-right point of the characteristic curve (up to 4.8% in head). This phenomenon occurs due to a slight mismatch between the geometric model of the impeller used in the calculation and the real pump model from the experiment. However, the average arithmetic relative deviation between numerical modeling and experiment for pump efficiency at 6 points is 0.39%, with an experimental efficiency measurement error of 0.72%. This meets the accuracy requirements for calculations. In the future, this methodology can be used for a series of optimization and strength calculations, as modeling does not require significant computational resources and takes into account the non-stationary nature of flow in the pump.

The second part presents numerical studies of the parameters of the lower ionosphere at altitudes of 40–90 km when heated by powerful high-frequency radio waves of various frequencies and powers. The problem statement is considered in the first part of the article. The main attention is paid to the interrelation between the energy and kinetic parameters of the disturbed $D$-region of the ionosphere in the processes that determine the absorption and transformation of the radio beam energy flux in space and time. The possibility of a significant difference in the behavior of the parameters of the disturbed region in the daytime and at nighttime, both in magnitude and in space-time distribution, is shown. In the absence of sufficiently reliable values of the rate constants for a number of important kinetic processes, numerical studies were carried out in stages with the gradual addition of individual processes and kinetic blocks corresponding at the same time to a certain physical content. It is shown that the energy thresholds for inelastic collisions of electrons with air molecules are the main ones. This approach made it possible to detect the effect of the emergence of a self-oscillating mode of changing parameters if the main channel for energy losses in inelastic processes is the most energy-intensive process — ionization. This effect may play a role in plasma studies using high-frequency inductive and capacitive discharges. The results of calculations of the ionization and optical parameters of the disturbed $D$-region for daytime conditions are presented. The electron temperature, density, emission coefficients in the visible and infrared ranges of the spectrum are obtained for various values of the power of the radio beam and its frequency in the lower ionosphere. The height-time distribution of the absorbed radiation power is calculated, which is necessary in studies of higher layers of the ionosphere. The influence on the electron temperature and on the general behavior of the parameters of energy losses by electrons on the excitation of vibrational and metastable states of molecules has been studied in detail. It is shown that under nighttime conditions, when the electron concentration begins at altitudes of about 80 km, and the concentration of heavy particles decreases by two orders of magnitude compared to the average $D$-region, large-scale gas-dynamic motion can develop with sufficient radio emission power The algorithm was developed based on the McCormack method and two-dimensional gas-dynamic calculations of the behavior of the parameters of the perturbed region were performed with some simplifications of the kinetics.

Mechanical unfolding of two identical in structure but differ in their amino acid sequences immunoglobulinbinding domains of proteins L and G under the action of external forces have been investigating  using the method of molecular dynamics with explicit model of solvent. Mechanical characteristics of these proteins have been calculated. It has been shown that in the way of the mechanical unfolding of both proteins appear intermediate states. Calculations revealed three significantly different ways of mechanical unfolding of proteins L and G.

We consider two possible computational methods of the interpretation of experimental data obtained by means of the magnetic force microscopy. These methods of macrospin distribution simulation and reconstruction can be used for research of magnetization reversal processes of nanodots in ordered 2D arrays of nanodots. New approaches to the development of high-performance superscale algorithms for parallel executing on a supercomputer clusters for solving direct and inverse task of the modeling of magnetic states, types of ordering, reversal processes of nanosystems with a collective behavior are proposed. The simulation results are consistent with experimental results.

This article is dedicated to numerical modeling of heat and mass transfer processes in microchannels. Microchannels are channels, that characteristic diameter is about 100 μm. Interest to the study of processes in them is growing every year, due to the rapid development of microfluid technique. The study was conducted using the software package σFlow. Isothermal and nonisothermal flows in microchannels of various configurations were considered. The obtained results were compared with available experimental and analytical data. In general for all problems a good agreement was obtained.

The paper presents an optimization approach to microstructure simulation. Porosity function was optimized by numerical method, grain-size model was optimized by complex method based on criteria of model quality. Methods have been validated on examples. Presented new regression model of model quality. Actual application of proposed method is 3D reconstruction of core sample microstructure. Presented results suggest to prolongation of investigations. 

The number of papers addressing the forecasting of the infectious disease morbidity is rapidly growing due to accumulation of available statistical data. This article surveys the major approaches for the shortterm and the long-term morbidity forecasting. Their limitations and the practical application possibilities are pointed out. The paper presents the conventional time series analysis methods — regression and autoregressive models; machine learning-based approaches — Bayesian networks and artificial neural networks; case-based reasoning; filtration-based techniques. The most known mathematical models of infectious diseases are mentioned: classical equation-based models (deterministic and stochastic), modern simulation models (network and agent-based).

On the basis of the MGD equations we consider 2D- and 3D- nonstationary problems about the evolution of perturbations in the lower atmosphere and the Earth’s ionosphere which are caused by the movement of large meteoroids along gently sloping paths of the entry with the simulation of their destruction by the momentary increase of the midship at the point of the pressure head maximum. According to the results of our numerical investigation we obtain and analyze the detailed spatial-temporal distributions of the main parameters of the plasma flows from which in particular a number of phenomena that are similar to those seen in the Chelyabinsk phenomenon follow.

Investigation of influence of non-equilibrium initial states and structural disorder on characteristics of anomalous slow non-equilibrium critical behavior of three-dimensional Ising model is carried out. The unique ageing properties and violations of the equilibrium fluctuation-dissipation theorem are observed for considered pure and disordered systems which were prepared in high-temperature initial state and then quenched in their critical points. The heat-bath algorithm description of ageing properties in non-equilibrium critical behavior of three-dimensional Ising model with spin concentrations p = 1.0, p = 0.8, and 0.6 is realized. On the base of analysis of such two-time quantities as autocorrelation function and dynamical susceptibility were demonstrated the ageing effects and were calculated asymptotic values of universal fluctuation-dissipation ratio in these systems. It was shown that the presence of defects leads to aging gain.

Problems of application of quasicellular networks for simulation of flows of visitors in different public spaces are considered. Quasicellular networks are basic discrete structures without signature. Proposed approach may be used to create simulations on micro and macro levels. It also may be used for creating geometrical models. There are also multi-flow systems for simulation of sports fans in a sports arena, propagation of fire and poison in public spaces. This approach satisfies the requirements of MOE of Russia № 7-3-113.