All issues

An overview is given for identification criteria of tip vortices, trailing from lifting surfaces of aircraft. $Q$-distribution is used as the main vortex identification method in this work. According to the definition of Q-criterion, the vortex core is bounded by a surface on which the norm of the vorticity tensor is equal to the norm of the strain-rate tensor. Moreover, following conditions are satisfied inside of the vortex core: (i) net (non-zero) vorticity tensor; (ii) the geometry of the identified vortex core should be Galilean invariant. Based on the existing analytical vortex models, a vortex center of a twodimensional vortex is defined as a point, where the $Q$-distribution reaches a maximum value and it is much greater than the norm of the strain-rate tensor (for an axisymmetric 2D vortex, the norm of the vorticity tensor tends to zero at the vortex center). Since the existence of the vortex axis is discussed by various authors and it seems to be a fairly natural requirement in the analysis of vortices, the above-mentioned conditions (i), (ii) can be supplemented with a third condition (iii): the vortex core in a three-dimensional flow must contain a vortex axis. Flows, having axisymmetric or non-axisymmetric (in particular, elliptic) vortex cores in 2D cross-sections, are analyzed. It is shown that in such cases $Q$-distribution can be used to obtain not only the boundary of the vortex core, but also to determine the axis of the vortex. These concepts are illustrated using the numerical simulation results for a finite span wing flow-field, obtained using the Reynolds-Averaged Navier – Stokes (RANS) equations with $k-\omega$ turbulence model.

The article presents the results of numerical modeling of the vortex spatial non-stationary motion of the medium arising near the lateral and bottom surfaces of the descent module during its movement in the atmosphere of Mars. The numerical study was performed for the high-speed streamline regime at various angles of attack. Mathematical modeling was carried out on the basis of the Navier – Stokes model and the model of equilibrium chemical reactions for the Martian atmosphere gas. The simulation results showed that under the considered conditions of the descent module motion, a non-stationary flow with a pronounced vortex character is realized near its lateral and bottom surfaces. Numerical calculations indicate that, depending on the angle of attack, the nonstationarity and vortex nature of the flow can manifest itself both on the entire lateral and bottom surfaces of the module, and, partially, on their leeward side. For various angles of attack, pictures of the vortex structure of the flow near the surface of the descent vehicle and in its near wake are presented, as well as pictures of the gas-dynamic parameters fields. The non-stationary nature of the flow is confirmed by the presented time dependences of the gas-dynamic parameters of the flow at various points on the module surface. The carried out parametric calculations made it possible to determine the dependence of the aerodynamic characteristics of the descent module on the angle of attack. Mathematical modeling is carried out on the basis of the conservative numerical method of fluxes, which is a finitevolume method based on a finite-difference writing of the conservation laws of additive characteristics of the medium using «upwind» approximations of stream variables. To simulate the complex vortex structure of the flow over descent module, the nonuniform computational grids are used, including up to 30 million finite volumes with exponential thickening to the surface, which made it possible to reveal small-scale vortex formations. Numerical investigations were carried out on the basis of the developed software package based on parallel algorithms of the used numerical method and implemented on modern multiprocessor computer systems. The results of numerical simulation presented in the article were obtained using up to two thousand computing cores of a multiprocessor complex.

This paper addresses the problem of the plane-parallel motion of an elliptic foil with an attached point vortex of constant strength in an ideal fluid. It is assumed that the position of the vortex relative to the foil remains unchanged during motion. The flow of the fluid outside the body is assumed to be potential (except for the singularity corresponding to a point vortex), and the flow around the body is noncirculatory. Special attention is given to the general position case in which the point vortex does not lie on the continuations of the semiaxes of the ellipse. The problem under consideration is described by a system of six first-order differential equations. After reduction by the motion group of the plane E(2) it reduces to a system of three differential equations. An analysis of this reduced system is made. It is shown that this system admits one to five fixed points which correspond to motions of the ellipse in various circles. By numerically investigating the phase flow of the reduced system near fixed points, it is shown that, in the general case, the system admits no invariant measure with a smooth positive definite density. Parameter values are found for which one of the fixed points of the reduced system is an unstable node-focus. It is shown that, as the variation of the parameters is continued, an unstable limit cycle can arise from an unstable fixed point via an Andronov – Hopf bifurcation. An analysis is made of bifurcations of this limit cycle for the case where the position of the point vortex relative to the ellipse changes. By constructing a parametric bifurcation diagram, it is shown that, as the system’s parameters are varied, the limit cycle undergoes a cascade of period-doubling bifurcations, giving rise to a chaotic repeller (a reversed-time attractor). To carry out a numerical analysis of the problem, the method of constructing a twodimensional Poincaré map is used. The search for and analysis of simple and strange repellers were performed backward in time.

An algorithm is proposed to identify parameters of a 2D vortex structure used on information about the flow velocity at a finite (small) set of reference points. The approach is based on using a set of point vortices as a model system and minimizing a functional that compares the model and known sets of velocity vectors in the space of model parameters. For numerical implementation, the method of gradient descent with step size control, approximation of derivatives by finite differences, and the analytical expression of the velocity field induced by the point vortex model are used. An experimental analysis of the operation of the algorithm on test flows is carried out: one and a system of several point vortices, a Rankine vortex, and a Lamb dipole. According to the velocity fields of test flows, the velocity vectors utilized for identification were arranged in a randomly distributed set of reference points (from 3 to 200 pieces). Using the computations, it was determined that: the algorithm converges to the minimum from a wide range of initial approximations; the algorithm converges in all cases when the reference points are located in areas where the streamlines of the test and model systems are topologically equivalent; if the streamlines of the systems are not topologically equivalent, then the percentage of successful calculations decreases, but convergence can also take place; when the method converges, the coordinates of the vortices of the model system are close to the centers of the vortices of the test configurations, and in many cases, the values of their circulations also; con-vergence depends more on location than on the number of vectors used for identification. The results of the study allow us to recommend the proposed algorithm for identifying 2D vortex structures whose streamlines are topologically close to systems of point vortices.