All issues

Mathematical model of infiltrative tumour growth taking into account transitions between two possible states of malignant cell is investigated. These transitions are considered to depend on oxygen level in a threshold manner: high oxygen concentration allows cell proliferation, while concentration below some critical value induces cell migration. Dependence of infiltrative tumour spreading rate on model parameters has been studied. It is demonstrated that if the level of tissue oxygenation is high, tumour spreading rate remains almost constant; otherwise the spreading rate decreases dramatically with oxygen depletion.

A two-dimensional system of excitable cells, describing by the FitzHugh-Nagumo model, has been used for a theoretical investigation of an action potential propagation (AP) in vascular plant tissues. It is shown that growth of electrical conductivity between cells increases the AP generation threshold and its propagation velocity in the homogeneous system, which has been formed by equal elements. The plant symplast has been
described by the heterogeneous system, including elements with low electrical conductivity, which simulate parenchyma cells, and elements with high electrical conductivity, which simulate sieve elements. Analysis of this system shows that the threshold of the AP generation is similar with this threshold in the homogeneous system
with low electrical conductivity; the velocity of the AP propagation is faster than one in this system.

Efficient method for numerical solving of the steady transport equation in x-y-z-geometry has been suggested. The equation is being solved on hexagonal mesh, reflecting real structure of the reactor active zone cross-section. Method of characteristics is used, that inherits all the outcomes from the two-dimensional r-z-geometry calculation. Two variants of the method of characteristics have been applied for solving the transport equation in a cell: method of short characteristics and its conservative modification. It has been confirmed that in three-dimensional geometry conservative method has advantage over pure characteristic and it produces highly accurate solution, especially for quasi-diffusion tensor components.

The given work is devoted aerodynamic properties of system of the bodies which are flowed round by a supersonic stream. The question on reduction of mutual influence with increase in the size characterising scattering of elements of system is considered. The method of construction of a grid is applied to current modeling from a set of grids. One of grids, regular with rectangular cells, is responsible for an interference between bodies
and serves for the description of an external nonviscous current. Other grids are  connected with surfaces of streamline bodies and allow to describe viscous layers about streamline bodies. These grids are imposed on the first, without combination of any knots. Boundary conditions are realized through interpolation of functions on borders from one grid on another.

Molecular dynamics (MD) simulations of rigid water model TIP4P-EW at ambient conditions were carried out. Delaunay’s simplexes were considered as structural elements of liquid water. Topological criterion which allows to identify the water microstructure in snapshot of MD cell was used to allocate its dense part. Geometrical analysis of water Delaunay’s simplexes indicates their strong flatness in comparison with a regular tetrahedron that is fundamentally different from the results for dense part of simple liquids. The statistics of TIP4P-EW water clusters was investigated depending on their cardinality and connectivity. It is similar to the statistics for simple liquids and the structure of this dense part is also a fractal surface consisting of the free edges of the Delaunay’s simplexes.

The effect of the nonlinear supratransmission in crystal of A₃B stoichiometry is studied by molecular dynamics on the example of Pt₃Al alloy. This effect is the transfer of energy at frequencies outside the phonon spectrum of the crystal. Research of the mechanisms of energy transport from the material surface to the interior is the important task, both from the theoretical point of view and from the prospects for practical application in the modification of near-surface layers by treatment with intense external influence of various types. The model was a three-dimensional face-centered cubic crystal whose atoms interact by means of the multiparticle potential obtained by the embedded atom method, which provides greater realism of the model in comparison with the use of pair potentials. Various forms of oscillation of the external influence region are considered. The possibility of energy transport from the crystal surface to the interior is shown by excitation of quasi-breathers near the region of influence and their subsequent destruction in the crystal and scattering of the energy stored on them. The quasibreathers are high-amplitude nonlinear atoms' oscillations of the alloy lightweight component at frequencies outside the phonon spectrum of the crystal. This effect was observed not with every oscillation's form of the region of influence. Quasi-breathers appeared most intensely near the region of influence with sinusoidal form oscillations. The results obtained indicate that the contribution of quasi-breathers to the energy transfer through the crystal increases with increasing amplitude of the influence. The range of amplitudes from 0.05 to 0.5 Å is considered. The frequency of the influence varied from 0.2 to 15 THz, which ensured the coverage of the entire spectrum of lowamplitude oscillations for this crystal's model. The minimum magnitude of the external effect amplitude at which this effect was observed was found to be 0.15 Å. At amplitudes greater than 0.5 Å, the cell rapidly decays for frequencies close to the optical branch of the phonon spectrum. The results of the study can be useful for laser processing of materials, surface treatment by low-energy plasma, and also in radiation materials science.

Certifying a transport airplane for the flights under icing conditions requires calculations aimed at definition of the dimensions and shapes of the ice bodies formed on the airplane surfaces. Up to date, software developed in Russia for simulation of ice accretion, which would be authorized by Russian certifying supervisory authority, is absent. This paper describes methodology IceVision recently developed in Russia on the basis of software FlowVision for calculations of ice accretion on airplane surfaces.

The main difference of methodology IceVision from the other approaches, known from literature, consists in using technology Volume Of Fluid (VOF — volume of fluid in cell) for tracking the surface of growing ice body. The methodology assumes solving a time-depended problem of continuous grows of ice body in the Euler formulation. The ice is explicitly present in the computational domain. The energy equation is integrated inside the ice body. In the other approaches, changing the ice shape is taken into account by means of modifying the aerodynamic surface and using Lagrangian mesh. In doing so, the heat transfer into ice is allowed for by an empirical model.

The implemented mathematical model provides capability to simulate formation of rime (dry) and glaze (wet) ice. It automatically identifies zones of rime and glaze ice. In a rime (dry) ice zone, the temperature of the contact surface between air and ice is calculated with account of ice sublimation and heat conduction inside the ice. In a glaze (wet) ice zone, the flow of the water film over the ice surface is allowed for. The film freezes due to evaporation and heat transfer inside the air and the ice. Methodology IceVision allows for separation of the film. For simulation of the two-phase flow of the air and droplets, a multi-speed model is used within the Euler approach. Methodology IceVision allows for size distribution of droplets. The computational algorithm takes account of essentially different time scales for the physical processes proceeding in the course of ice accretion, viz., air-droplets flow, water flow, and ice growth. Numerical solutions of validation test problems demonstrate efficiency of methodology IceVision and reliability of FlowVision results.

Kuramoto model of non-linearly coupled oscillators provides a simple but effective approach to the study of the synchronization phenomenon in complex systems. In the present article we consider a particular Kuramoto model with three non-identical oscillators associated with a multi-cell radial profile of the solar meridional circulation. The top and the bottom oscillators are coupled through the middle one. The main difference of the present Kuramoto model from the previous ones consists in the non-identical coupling: coupling coefficients which tie the middle oscillator with the top and the bottom ones are different. We investigate how the value of the coupling asymmetry of the middle oscillator influences the synchronization. In the present model the synchronization conditions appear to be different the classical Kuramoto model allowing the synchronization to be reached with weaker coupling. We perform a reconstruction of coupling coefficients from the phase difference between the top and the bottom oscillators, assuming that the synchronization is reached and the natural frequencies are known. The absolute cumulative coupling is uniquely determined by the phase difference between the top and the bottom oscillators and the coupling asymmetry of the middle oscillator. In general case, higher values of the coupling asymmetry of the middle oscillator correspond to lower cumulative coupling. A unique coupling reconstruction with unknown coupling asymmetry is possible in general case only for the weak cumulative coupling. Deviations from the general case are discussed. We perform a model simulation with natural frequencies estimated from the velocities of the solar meridional flow. Heliseismological observations of the deep flow may be attributed either to the middle cell or to the deep one. We discuss the difference between these two cases in terms of the coupling reconstruction.

In this work, parallel method for solving single-phase flow problems in a fractured porous media is considered. Method is based on the representation of fractures by surfaces embedded into the computational mesh, and known as the embedded discrete fracture model. Porous medium and fractures are represented as two independent continua within the model framework. A distinctive feature of the considered approach is that fractures do not modify the computational grid, while an additional degree of freedom is introduced for each cell intersected by the fracture. Discretization of fluxes between fractures and porous medium continua uses the pre-calculated intersection characteristics of fracture surfaces with a three-dimensional computational grid. The discretization of fluxes inside a porous medium does not depend on flows between continua. This allows the model to be integrated into existing multiphase flow simulators in porous reservoirs, while accurately describing flow behaviour near fractures.

Previously, the author proposed monotonic modifications of the model using nonlinear finite-volume schemes for the discretization of the fluxes inside the porous medium: a monotonic two-point scheme or a compact multi-point scheme with a discrete maximum principle. It was proved that the discrete solution of the obtained nonlinear problem preserves non-negativity or satisfies the discrete maximum principle, depending on the choice of the discretization scheme.

This work is a continuation of previous studies. The previously proposed monotonic modification of the model was parallelized using the INMOST open-source software platform for parallel numerical modelling. We used such features of the INMOST as a balanced grid distribution among processors, scalable methods for solving sparse distributed systems of linear equations, and others. Parallel efficiency was demonstrated experimentally.

In this paper, a mathematical model of cellular tissue dynamics is considered. The first part gives the conclusion of the model, the main provisions and the formulation of the problem. In the second part, the final system is investigated numerically and the simulation results are presented. It is postulated that cellular tissue is a three-phase medium that consists of a solid skeleton (which is an extracellular matrix), cells and extracellular fluid. In addition, the presence of nutrients in the tissue is taken into account. The model is based on the equations of conservation of mass, taking into account mass exchange, the equations of conservation of momentum for each phase, as well as the diffusion equation for nutrients. The equation describing the cellular phase also takes into account the term describing the chemical effect on the tissue, which is called chemotaxis — the movement of cells caused by a gradient in the concentration of chemicals. The initial system of equations is reduced to a system of three equations for finding porosity, cell saturation and nutrient concentration. These equations are supplemented by initial and boundary conditions. In the one-dimensional case, the distribution of porosity, concentration of the cell phase and nutrients is set at the initial moment of time. A constant concentration of nutrients is set on the left border, which corresponds, for example, to the supply of oxygen from the vessel, as well as the flow of cell concentration on it is zero. Two types of conditions are considered at the right boundary: the first is the condition of impermeability of the right boundary, the second is the condition of constant concentration of the cell phase and zero flow of nutrient concentration. In both cases, the conditions for the matrix and extracellular fluid are the same, it is assumed that there is a source of nutrients (blood vessel) on the left border of the modeling area. As a result of modeling, it was revealed that chemotaxis has a significant effect on tissue growth. In the absence of chemotaxis, the compaction zone extends to the entire modeling area, but with an increase in the effect of chemotaxis on the tissue, a degradation area is formed in which the concentration of cells becomes lower than the initial one.